3452550 Removing and installing/replacing DSC sensor

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DISCHARGE (ESD PROTECTION) .

Necessary preliminary tasks

Lift carpet (1) and fold back to side.

Remove underlay (2).

Disconnect plug connection.

Installation:

Ensure proper locking of plug connector.

Slacken screws (3)

Release screws (4) and remove bracket with yaw sensor.

Installation:

Tightening torque 34 51 3AZ, see 34 51 SLIP CONTROL SYSTEM (DSC) . .

Fig 1: Identifying Carpet, Underlay And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing DSC sensor:

Release screws (1) and modify DSC sensor (2).

Installation:

Tightening torque 34 51 2AZ, see 34 51 SLIP CONTROL SYSTEM (DSC) . .

Fig 2: Identifying DSC Sensor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Carry out calibration/adjustment of DSC sensor.