51 71 Seals and Loose Body Parts

WARNING: This page is about a different variant/trim than selected.

SEALS AND LOOSE BODY PARTS - TIGHTENING TORQUE SPECIFICATION

-	Type	Thread	Tightening specification	Measure
1AZ Rear spoiler	E91	-	Screw	3 Nm
-	-	-	Nut	7 Nm
2AZ Tension strut in engine compartment	E81, E82, E87, E88, E90, E91, E92, E93	M10	Replace screws	-
-	-	-	Jointing torque	40 Nm
-	-	-	Torque angle	60°
-	E81, E82, E87, E88, E90, E91, E92, E93	M12 x 1.5	Replace screws	-
-	-	-	Jointing torque	100 Nm
-	-	-	Torque angle	100°
3AZ Tension strut to rear axle	E91	M12	Replace screws	-
-	-	-	Jointing torque	100 Nm
-	-	-	Torque angle	90°
-	E91	M10	-	50 Nm
4AZ Support tube to support, steering column upper section	E87, E90, E91, E92, E93	M8	-	19 Nm
5AZ Support tube to body	E87, E90, E91, E92, E93	M8	-	21 Nm
6AZ Heater to support tube	E87, E90, E91, E92, E93	-	-	4 Nm
7AZ Bracket, handle, to body	E82, E87, E90, E91	-	self-tapping screw	3.5 Nm
8AZ Bracket, suspension, dividing net to body	E91	-	-	11 Nm
9AZ Multifunction pan to body	E81, E82, E87, E90, E91, E92, E93	M6	-	8 Nm
10AZ V-strut, front axle carrier	E93	M8	Replace screws	-
-	-	-	Jointing torque	56 Nm
-	-	-	Torque angle	90°
-	E93	M10	Replace screws	-
-	-	-	Jointing torque	100 Nm
-	-	-	Torque angle	90°
-	E88	M10 to front axle carrier, front	-	50 Nm
-	E88	M10 to blind rivet nut	Jointing torque	60 Nm
-	-	-	Torque angle	105°
-	E88	M10 to captive nut	Replace captive nut	50 Nm
-	E88	M12	Jointing torque	100 Nm
-	-	-	Torque angle	105°
11AZ Diagonal strut, front end	E88, E93	Nut	Replace nut	56 Nm
-	E88, E93	Screw	Replace screws	-
-	-	-	Jointing torque	56 Nm
-	-	-	Torque angle	90°
12AZ Protecting skid / mounting bracket to front axle carrier	E93	M8	Replace screws	-
-	-	-	Jointing torque	56 Nm
-	-	-	Torque angle	90°
-	E88	M10	Replace screws	50 Nm
13AZ Rear middle tension strut to underbody bracket	E93 from 03_2007	M8	-	28 Nm
14AZ Battery carrier to body	E93	M8	-	19 Nm
15AZ Vibration damper to battery carrier	E93	M8	-	19 Nm
16AZ Grounding strap to body	E93	M6	-	8 Nm
17AZ Bulkhead connection, suspension cross-brace, to holder, spring suspension cross-brace	E92/M3	M12 x 1.5	Replace screw	-
-	-	-	Jointing torque	100 Nm
-	-	-	Torque angle	100°
18AZ Suspension cross-brace to bulkhead connection, suspension cross-brace	E92/M3	M8	Replace screws	34 Nm
19AZ Suspension cross-brace to bulkhead connection, suspension cross-brace/ring, suspension cross-brace	E92/M3	M8	Replace nuts	34 Nm
20AZ Tension strut to underbody cross-member	E88, E93	M10	-	50 Nm
21AZ Tension strut to frame side member locating bushing	E88, E93 from 03_2007	M12	Jointing torque	100 Nm
-	-	-	Torque angle	105°
22AZ Tension struts to underbody triangle	E88, E93 from 03_2007	M12	Jointing torque	100 Nm
-	-	-	Torque angle	105°
23AZ Left tension strut to right tension strut (rear axle)	E88, E93 from 03_2007	M10	Jointing torque	56 Nm
-	-	-	Torque angle	105°
24AZ Rear middle tension strut to underbody bracket/triangle bracket	E93 up to 03_2007	M8	Jointing torque	19 Nm
25AZ Tension strut to frame side member locating bushing	E93 up to 03_2007	M12	Jointing torque	100 Nm
-	-	-	Torque angle	90°
26AZ Left and right tension strut to underbody triangle	E93 up to 03_2007	M12	Jointing torque	100 Nm
-	-	-	Torque angle	90°
27AZ Strut, rollover protection system, to rollover protection system	E88, E93	M10	Jointing torque	56 Nm
-	-	-	Torque angle	100°
28AZ Strut, rollover protection system, to body	E88, E93	M10	Jointing torque	56 Nm
-	-	-	Torque angle	100°