65 83 590 Removing and Installing/Replacing Gyro Sensor Drive For Car Communication Computer
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
(Coupe).
Necessary preliminary tasks:
- Remove Car Communication Computer . Refer to 65 83 010 Removing and Installing/Replacing Car Communication Computer .
If necessary, cut through warranty seal.
Release bolts (1).
Remove floor pan (2) towards bottom and set down.
IMPORTANT:
Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!
When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.
Release bolt (1).
Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).