Special Tools Required
- 00 9 450
- 12 7 192
- 64 1 020 RELEASE HOOK
Read and comply with notes on protection against electrostatic damage (ESD protection). See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) (Coupe).
Risk of damage!
Place Car Communication Computer on special tool 12 7 192 (antistatic mat) and earth/ground.
Necessary preliminary tasks:
- Remove front trim for Car Communication Computer . Refer to 65 83 010 Removing and Installing/Replacing Car Communication Computer .
If necessary, cut through warranty seal.
Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).
Release bolts (1).
Feed out bridge (2).
Installation:
Use special tool 00 9 450 to tighten down screws.
Cut through stickers at marked points (1).
Release screws (2) and remove trim (3).
Installation:
Use special tool 00 9 450 to tighten down screws.
Release screws (1) with magnetic screwdriver.
Installation:
Lug (2) of DVD drive must be above lug (3) of Car Communication Computer.
Turn Car Communication Computer through 180° and carefully feed out DVD drive.
Carefully disconnect plug connections (1, 2).
Remove DVD drive (3).
Installation:
Ensure correct cable routing.
After installation:
On cars before March 2006 it is essential after replacing the DVD drive to carry out a measures plan or a software update as per SSS/Progman/CIP for BMW/MINI service functions.