Special Tools Required
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection)!
See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
(Coupe).
Necessary preliminary tasks:
- Remove front trim for Car Communication Computer . Refer to 65 83 560 Removing and installing/replacing front trim for Car Communication Computer .
If necessary, cut through warranty seal.
Raise cover (1) with special tool 64 1 020 all round and remove from Car Communication Computer (2).
Release bolts (1).
Feed CD drive for Car Communication Computer (2) in direction of arrow out of Car Communication Computer (3) and set down.
Installation:
Ensure correct routing of cables.
Release bolts (1).
Remove CD drive trim (2) in direction of arrow from CD drive for Car Communication Computer (3).
Installation:
Ensure correct routing of cables.
Cut through warranty seal (1) at marked point.
Release screw (2).
Lift side cover out of mounting (3) and carefully place to one side.
Disconnect plug connection (1) and remove CD drive.
Installation:
Ensure correct routing of cables.