65 75 071 Removing And Installing (Replacing) Module For Passenger Compartment Sensor
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD protection).
. See 61 35... NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE)
(Coupe).
Necessary preliminary tasks:
- Remove complete ceiling light (rear) . Refer to 63 31 004 REMOVING AND INSTALLING OR REPLACING COMPLETE CEILING LIGHT (REAR, WITH MODULE FOR PASSENGER COMPARTMENT PROTECTION) .
Open retaining shook (1) in direction of arrow and remove module for passenger compartment sensor (2) from trim (3).
Installation:
Retaining hooks (1) must not be damaged.
Arrow (4) must point in opposite direction to direction of travel.
Replacement:
Carry out programming/coding for BMW/MINI service functions in Progman.