Special Tools Required
WARNING: This page is about a different variant/trim than selected.
- 00 9 317 TRIM PANEL WEDGE (138i)
Necessary preliminary tasks:
- Remove front seat . Refer to 52 13 000 Removing And Installing Left Or Right Front Seat (Normal/Manual) .
NOTE:
Picture shows installed seat by way of example.
Raise lock (3) and lever out handle
- for backrest angle adjustment
- for seat height adjustment
with special tool 00 9 317 .
Release screw (1).
Tightening torque, see 52 10 06AZ in 52 10 FRONT SEATS .
NOTE:
Trim (2) is engaged in marked area.
Press lock (3) and pull trim (2) off seat mechanism.
If necessary, lever out carefully with special tool 00 9 317 .
If necessary, unlock plug connection (1) for backrest width adjustment and disconnect.
If necessary, unlock plug connection (2) for lumbar support and disconnect.
Replacement:
If necessary, remove backrest width adjustment switch and lumbar support switch.
Installation:
Make sure backrest width adjustment and lumbar support switches are correctly engaged.