52 13 034 Removing And Installing/Replacing Release Mechanism On Left Or Right Front Seat (Normal/Manual)

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Lever out trim in upward direction (1) with plastic wedge.

Slide trim forwards (2) and feed out over release handle.

Installation:

Check tabs (3) for correct seating in release mechanism.

Clip trim noticeably into place.

Fig 1: Checking Tabs For Correct Seating In Release Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Front seat (electric) only:

Unfasten plug connection (1) and disconnect.

Replacement only:

Unclip switch (2).

Fig 2: Identifying Plug Connection & Switch

Courtesy of BMW OF NORTH AMERICA, INC.

Detach backrest cover in marked area.

Fig 3: Detaching Backrest Cover In Marked Area

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Danger of mixing up screws.

Release screws (1).

Release screw between backrest cover and release mechanism.

Fig 4: Releasing Screw Between Backrest Cover & Release Mechanism

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cables (1) out of cable holder (2).

Unclip cable holder (3) from backrest frame.

Fig 5: Identifying Bowden Cables & Cable Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook seat covers on left and right.

Lever out retaining clip (1) on left and right.

Installation:

Replace retaining clip (1).

Make sure retaining clip (1) is correctly seated.

Fig 6: Identifying Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip ball socket (1) from ball head on left and right.

Installation:

Ball socket (1) must snap audibly into place.

Ball socket (1) must be able to move freely on ball head.

Feed Bowden cable out of guide (2) and backrest frame.

Fig 7: Identifying Ball Socket & Guide

Courtesy of BMW OF NORTH AMERICA, INC.