52 14 050 Removing And Installing/Replacing Lumbar Cushion On Front Seat

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

Detach backrest cover (1) from backrest frame.

Fig 1: Identifying Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock quick connector and detach air hoses - blue (1) and red (2) - from valve housing (3).

NOTE: Connections are coded against incorrect assembly.

Fig 2: Identifying Air Hoses Blue & Red

Courtesy of BMW OF NORTH AMERICA, INC.

Detach lumbar cushion (1) from spring wire (2).

Installation:

Attach lumbar cushion (1) to second and fourth wires from below.

Unclip air hoses (3) from holder.

Fig 3: Identifying Lumbar Cushion & Spring Wire

Courtesy of BMW OF NORTH AMERICA, INC.

Press back padding (1) a little.

Pull out lumbar cushion (2) towards top.

Feed air hoses out of backrest frame and spring wire.

Fig 4: Identifying Padding & Lumbar Cushion

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check lumbar cushion at top (1) and bottom (2) for damage.

Air hoses (3) must not be kinked.

Fig 5: Checking Lumbar Cushion At Top & Bottom For Damage

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: