51 24 004 Adjusting Rear Lid Lock (Lower Section Of Rear Lid Lock)

WARNING: This page is about a different variant/trim than selected.

NOTE: Rear lid must be correctly adjusted to fit before adjustment of rear lid lock.

If necessary Adjust rear lid . See 41 62 014 ADJUSTING REAR LID .

For ideal adjustment, refer to Body gap dimensions.

Screw in detent buffers for rear lid on left/right completely.

Fig 1: Locating Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Check fulcrum pads on lower section of rear lid lock for damage and replace if necessary.

Fig 2: Locating Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Version with cover caps on rear apron trim:

If necessary, remove cover caps.

Slacken screws in lower section of rear lid lock until it is just able to move and centers itself.

The lower section of the rear lid lock must not scrape against the rear lid lock.

Fig 3: Locating Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Adjusting lower section of rear lid lock: Close rear lid.

This enables the lower section of the rear lid lock to adjust itself correctly.

Open rear lid.

Tighten down screws on lower section of rear lid lock.

Tightening torque, see 51 24 6AZ in 51 24 REAR LID LOCKS (E60, E63, E64).

Tightening torque, see 51 24 2AZ in 51 24 REAR LID LOCKS (E82, E88, E90, E92).

Check adjustment of rear lid and rear lid lock, repeating adjustment if necessary.

Fig 4: Locating Rear Lid Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew detent buffer until closed rear lid abuts against left/right detent buffers.

IMPORTANT: The rear lid must not be higher than the side panels, otherwise there is preload on height adjustment!

Fig 5: Locating Rear Lid

Courtesy of BMW OF NORTH AMERICA, INC.