51 13 280 Removing And Installing/Replacing Trim Strip On Roof Frame At Left Or Right

WARNING: This page is about a different variant/trim than selected.

Special Tools Required

Lever out trim strip (1) with special tool 00 9 321 starting at rear.

Unclip trim strip (1) in direction of arrow.

Fig 1: Identifying Trim Strip With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) and seals (2) on trim strip (3) must not be damaged.

If necessary, replace faulty clips (1).

Position of clips (1) on trim strip (3) is determined by notch (4).

Fig 2: Identifying Clips & Seals

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Push trim strip (1) at front into seal (2).

Trim strip (1) must be flush with edge (3) at rear.

Fig 3: Identifying Trim Strip & Edge

Courtesy of BMW OF NORTH AMERICA, INC.