51 43 075 Removing And Installing/Replacing Side Trim Panel, Footwell, On A-Pillar, Right
WARNING: This page is about a different variant/trim than selected.
Special Tools Required
Necessary preliminary tasks:
- Remove front entrance cover strip (inside)
Detach mucket (1) in area of side trim panel (2).
Unclip side trim panel (2) with special tool 00 9 317 in direction of arrow at retaining points (3) and remove.
Installation:
If necessary, lever out clips (1) remaining in bores.
If necessary, replace faulty clips (1).
Position side trim panel (2) preinstalled with clips (1) on associated bores and clip into place.