51 12 801 Replacing Bracket For Rear Bumper At Left Or Right

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

If necessary, feed aerial cable (1) out of holder.

Installation:

Ensure correct lead routing.

Fig 1: Identifying Feed Aerial Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Release nuts (2) and remove holder (3).

Fig 2: Identifying Holder, Screws & Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on holder (2) must not be damaged.

Fig 3: Identifying Catches On Holder

Courtesy of BMW OF NORTH AMERICA, INC.