51 12 156 Removing And Installing/Replacing Rear Bumper Trim

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE:

Description is shown on the E82 by way of example. There may be differences in detail in the case of other models.

Prior to removing, pay attention to the exact installation position with respect to the adjoining components.

Release screws (1) on wheel arch trim (2) on left/right.

Installation:

Make sure wheel arch trim (2) is in correct position.

Fig 1: Identifying Wheel Arch Trim & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Picture shows E92. Screw (1) not fitted on E82/E88.

Bend wheel arch cover (2) in area (A) to one side and release screw (3) on left/right.

Fig 2: Identifying Wheel Arch Cover & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on bumper trim (2).

Fig 3: Identifying Bumper Trim & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:

Risk of damage!

Do not detach bumper trim (1) at sides

The following work must be carried out with a second person assisting:

NOTE: Picture shows E92.

Pull bumper trim (1) towards rear and release from catches (2).

Fig 4: Pulling Bumper Trim & Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Press down catch (2).

Remove bumper trim (1) towards rear with aid of a 2nd person.

If necessary, disconnect plug connection on ultrasonic transducers.

Fig 5: Identifying Bumper Trim & Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) and guides (2) must not be damaged.

If necessary, replace faulty sheet nuts (3) on left/right.

Replacement:

If necessary, modify ultrasonic transducer .
Modify towing eye cover

Fig 6: Identifying Catches & Guides
Courtesy of BMW OF NORTH AMERICA, INC.