51 16... Removing And Installing/Replacing Mounting For Cup Holder At Front

WARNING: This page is about a different variant/trim than selected.

Necessary Preliminary tasks:

Release screws (1).

Remove holder (2) and trim (3).

Installation:

Spring (4) on holder (2) must not be damaged or missing.

Fig 1: Identifying Holder, Trim & Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts must not be damaged or missing:

Screw mountings
Spring
Trim

Fig 2: Identifying Spring, Trim & Screw Mounting
Courtesy of BMW OF NORTH AMERICA, INC.