51 31 021 Removing And Installing/Replacing Rubber Frame For Windscreen

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Rubber frame (1) features an aluminum section inlay (2). Carefully unwind rubber frame (1) (windscreen breakage).

NOTE:

Tear-off lip (5) may be stuck to adhesive (4).

When rubber frame (1) is removed, tear-off lip (5) can tear off and remain in vehicle.

Fig 1: Identifying Rubber Frame, Tear-Off Lip & Aluminum Section Inlay

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean cutout.

Area (A) is fitted with acoustic foam material.

Pay attention to center marking on rubber frame (1) and windscreen.

Replacement of rubber frame without windscreen removal:

Detach tear-off lip (5) from rubber frame (1).

If adhesive leaks over tear-off lip (5) at bridge (4), this area must be cut out partially.

To facilitate installation, coat rubber frame (1) and body cutout with water.

Replacement of rubber frame with removed or new windscreen:

Fig 2: Locating Cowl Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Fit rubber frame (1) with tear-off lip (4).