51 47... Removing And Installing/Replacing Lip On Underbody Panelling On Left Or Right

WARNING: This page is about a different variant/trim than selected.

NOTE:

Prior to removing, pay attention to the exact installation position with respect to the adjoining components.

The operation is described on the left side; proceed in the same way for the right side.

Release expansion rivets (1).

Release catches (2).

Feed out lip (3) towards rear from underbody panelling and remove.

Installation:

If necessary, replace faulty expander rivets (1).

Fig 1: Identifying Expansion Rivets & Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Catches (1) on lip (2) must not be damaged.

Fig 2: Identifying Catches On Lip

Courtesy of BMW OF NORTH AMERICA, INC.