51 47 490 Removing And Installing/Replacing Front Underbody Protection

WARNING: This page is about a different variant/trim than selected.

NOTE: Description is shown on the E87 by way of example. There may be differences in detail in the case of other models.

Release screws (1).

Pull underbody protection (2) forward under bumper trim (3).

Installation:

Centre underbody protection (2) and tighten down screws (1).

Fig 1: Identifying Underbody Protection & Bumper Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

If necessary, modify or replace front section (1) underbody protection
Modify sheet nuts, replace defective nuts if necessary

Fig 2: Identifying Underbody Protection & Front Section
Courtesy of BMW OF NORTH AMERICA, INC.