51 14 110 Removing And Installing/Replacing Rear Model Designation
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
The Instructions for number/letter combination cementing serve as the basis for these repair instructions and must be followed without fail.
Fitting dimensions (E82/E88):
Stick on adhesive tape (1) horizontally according to dimension "A".
Mark reference point (2) according to dimension "B".
Position model designation at reference point (2) and stick on.
Dimensions:
A = 23.5 mm
B = 26.5 mm
NOTE:
Measurements C, D and E are for information purposes only, as determined by carrier film.
118d: C = 5.5 mm, D = 8 mm, E = 13.5 mm
118i: C = 5.5 mm, D = 8 mm, E = 16 mm
120d ...123d: C = 8 mm, D = 6.5 mm, E = 13.5 mm
120i ...128i: C = 8 mm, D = 6.5 mm, E = 16 mm
135i: C = 6.8 mm, D = 6.5 mm, E = 16 mm