Removal of luggage compartment floor

WARNING: This page is about a different variant/trim than selected.

Open weld joints in area (1).

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

With removed tail panel:

Mark severance cut (1) and disconnect tensioning strap (2).

Installation:

Mark severance cut on new part C-pillar reinforcement acc. to vehicle + 25 mm material extra and disconnect.

Bond tensioning strap in area of the overlap with 3 blind rivets N3 and rivet.

Fig 2: Identifying Severance Cut And Tensioning Strap

Courtesy of BMW OF NORTH AMERICA, INC.

For removed side wall:

Release welded connection in area (1) and remove tensioning strap (2).

Installation:

Bond tensioning strap in area (1) with 3 blind rivets N3 and rivet.

Fig 3: Identifying Welded Connection Area And Tensioning Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Mark severance cut (2) next to reinforcement (3) and disconnect.

Fig 4: Identifying Welding Areas, Severance Cut And Reinforcement

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Remove the trunk floor.

NOTE: Tail panel and side wall hidden for better overview.

Fig 5: Identifying Welding Areas On Luggage Compartment Floor

Courtesy of BMW OF NORTH AMERICA, INC.