51 23 400 Removing And Installing/Replacing Left Or Right Actuator (Active Pedestrian Protection)
WARNING: This page is about a different variant/trim than selected.
WARNING:
Adhere to the following safety information so as to avoid a danger of injury by the actuator:
The BATTERY NEGATIVE LEAD must be clamped off prior to work on the actuator or engine compartment lid!
Do not exert any force on the actuator.
Incorrect handling may result in triggering of the actuator and thereby cause serious injury.
Necessary preliminary tasks:
Disconnect BATTERY NEGATIVE LEAD .
Remove COWL PANEL COVER .
Lever out clip (1).
Release screws (2) and remove cavity sealing (3).
Unlock plug connection (1) and disconnect.
Release bolt (2) and remove actuator (3).
Tightening torque 41 61 4AZ .
Comply with notes regarding HANDLING ACTIVE PEDESTRIAN PROTECTION .