The body must be anchored as follows for reshaping

If using vehicle-specific/universal straightening attachment sets (Carbench/Celette/Car-O-Liner), it is necessary to secure the body additionally  with 4 retaining clips to the spot flange of the entrance or to the 4 jacking points. The spot flange (if available) is to be preferred.

If using universal electronic or mechanical straightening systems (Car-O-liner/Celette), it is necessary to secure the body with 4 retaining clips to the spot flange of the entrance or to the 4 jacking points. The spot flange (if available) is to be preferred. In addition  anchor at least 2 points with the securing set.

Failure to comply with these instructions will result in damage to the body during reshaping in non-damaged areas. Vehicle-specific straightening attachments and universal mounts may be damaged.

• Repairs affecting the mounting points of assemblies and chassis/suspension components must be carried out on the straightening bench with the matching straightening attachment set or specification sheet for the vehicle.

  Straightening attachments and specification sheets are also available for the top section, e.g.: door pillars, convertible top mounts, cowl, rear lid hinges, etc.

• Check windshield and rear window apertures for curvature by inserting the original glass.
• Take the gap dimensions for doors, engine hood and rear lid from the vehicle-specific gap dimension diagram.