Hardening time
WARNING: This page is about a different variant/trim than selected.
Do not move the vehicle before the adhesive has hardened.
Check the degree of hardness of the adhesive with a fingernail.
If the adhesive cannot be pressed in any further with a fingernail, the vehicle may be moved (without engine force) for further processing applications (e.g. painting).
Vehicle strength for driving applications is achieved after:
48 hours at min. 15°C object temperature (corresponding to approx. 18°C room temperature).
or 1 hour in the spray booth (spray booth temperature 80°C/object temperature 60°C).
When using radiant heaters, make sure that the object temperature does not exceed 85°C. Excessively high temperatures will destroy the adhesive.