Straight Shank Rivet Nut

WARNING: This page is about a different variant/trim than selected.

IMPORTANT:

Risk of damage!

Failure to comply with these instructions may result in the drill bit slipping and causing significant paintwork damage.

Mark position of bore and then punch-mark component

Fig 1: Marking Position Of Bore & Then Punch-Mark Component
Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT:
If the determined drill bit diameter is not observed:
- the knurling on the straight shank rivet nut is rendered useless
- the component will be damaged when the straight shank rivet nut is inserted
Determining suitable drill bit:

Depending on the rivet nut shank diameter, the next drill bit diameter higher (5/10 step) can be used.

E.g. with a shank diameter of 10.1 mm, the 10.5 mm drill bit can be used. The 11.0 mm drill bit must not be used.
Drill bore with determined drill bit and deburr, pilot-drill with a smaller drill bit if necessary

Fig 2: Drilling Bore With Determined Drill Bit & Deburr, Pilot-Drill With Smaller Drill Bit
Courtesy of BMW OF NORTH AMERICA, INC.
Clean component, eliminate paintwork damage if necessary

Fig 3: Cleaning Component, Eliminate Paintwork Damage
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To avoid corrosion, stop chips/swarf by means of cavity sealing.
Follow instructions on corrosion protection . Refer to 41 00... Corrosion Protection .
Preserving cavity

Fig 4: Preserving Cavity
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT:
Follow manufacturer's operating instructions.

Make sure straight shank rivet nut correctly contacts component.
Set straight shank rivet nut with hand rivet gun
NOTE: According to the manufacturer, the pictured tool is suitable up to an M8 thread.

Fig 5: Setting Straight Shank Rivet Nut With Hand Rivet Gun
Courtesy of BMW OF NORTH AMERICA, INC.