4.0 Adhesive application
WARNING: This page is about a different variant/trim than selected.
- Processing temperature of adhesive cartridge 15°C - 25°C.
- Insert adhesive cartridge in adhesive gun, remove cap and allow both adhesive components to emerge. Strip adhesive components uniformly and attach mixing tube.
- Allow approx. 10 cm of mixed adhesive to emerge and then apply the mixed adhesive first on one side of the adhesive area.
- After applying the adhesive, check whether an adhesive component has emerged at the back of the cartridge. If yes, break off the bonding procedure. Clean new component. Use new adhesive cartridge. Contact national hotline.
- Use a spatula to spread the adhesive over the adhesive area. Thickness of layer approx. 2 mm (dependent on adhesive gap).
- Potlife of mixed adhesive approx. 2 hours. A change of mixer is only necessary if over a period of 1 hour no material has flowed through the mixer.
- Join, secure and rivet and/or weld new parts in accordance with repair instructions.
- Remove excessive glue with paper or cloths.