61 61 Windshield Wipers
WARNING: This page is about a different variant/trim than selected.
WINDSHIELD WIPERS- TIGHTENING TORQUE SPECIFICATION TABLE
| - | Type | Thread | Tightening specification | Measure |
|---|---|---|---|---|
| 1AZ Wiper motor secured to wiper bracket | E52 | M6 | - | 9.9 Nm |
| 2AZ Parked position stop to wiper console | - | - | - | - |
| 3AZ Wiper contact pressure motor to wiper console | - | - | - | - |
| 4AZ Motor crank to wiper motor | E52 | M8 | - | 27 Nm |
| 5AZ Wiper shaft nut to body | - | - | - | - |
| 6AZ Wiper bracket to firewall | E52/E53/E60/E61/E63/E64/E65/E66/E67/E70/E71/E81/E82/E85/E86/E87/E88/E90/E91/E92/E93 | M6 | If necessary, observe tightening sequence. | 10 Nm |
| 7AZ Wiper bracket to rubber buffer | E53 | M6 | - | 10 Nm |
| 8AZ Wiper arms | E53 | - | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 30 Nm |
| 9AZ Wiper arms | E52 | - | - | 27 Nm |
| 10AZ Adjusting screw, wiper arm, right side | E65/E66/E67 | - | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 30 Nm |
| 11AZ Wiper arms | E85/E86 | - | - | 25 Nm |
| - | E90/E91/E92/E93 | M10 | - | 30 Nm |
| - | E70/E71/E81/E82/E87/E88 | M10 | - | 35 Nm |
| 12AZ Wiper arm, left side | E60/E61/E63/E64 | M10 | For torque, see inscription on wiper arm. Due to risk of releasing: check TT after approx. 50 mins. settling time. |
30 or 35 Nm |
| - | E65/E66/E67 | M10 | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 45 Nm |
| 13AZ Wiper arm, right side | E60/E61/E63/E64 | 2xM8 | For torque, see inscription on wiper arm. Due to risk of releasing: check TT after approx. 50 mins. settling time. | 20 Nm |
| - | E60/E61/E63/E64 | 1xM8 1xM10 |
Wiper arm without torque label. | 17 or 35 Nm |
| - | E65/E66/E67 | M10 | Due to risk of releasing: check tightening torque after approx. 15 mins. settling time. | 35 Nm |
| 14AZ Adjusting screw, wiper arm, right side | E60/E61/E63/E64 | - | - | 20 Nm |
| 15AZ Bearing block tension strut/cowl panel | E60/E61/E63/E64 | - | - | 24 Nm |
| 16AZ Nut to deflection lever | E65/E66/E67 | M10 | - | 30 Nm |