61 71 015 Removing And Installing/Replacing A Spray Nozzle In Windshield Washer System

WARNING: This page is about a different variant/trim than selected.

NOTE: The jet nozzles of the windshield washer system are preset at the factory and cannot be readjusted.

Disconnect plug connection (1).

Detach hose (2) from spray nozzle (4).

Press in retaining lug (3) in direction of arrow and feed out spray nozzle (4) through opening.

Installation:

Make sure spray nozzle (4) is correctly seated
Ensure hose is laid without kinks.

Fig 1: Pressing Retaining Lug
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of spray nozzle (4) must not be damaged or missing:

(1) Plug connection
(2) Hose connection
(3) Detent lug, bottom
(5) Detent lug, top

Fig 2: Identifying Plug Connection, Hose Connection & Detent Lug
Courtesy of BMW OF NORTH AMERICA, INC.