67 62 000 Removing And Installing Or Replacing Flat Motor For Front Left Or Right Power Window Unit

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove sound insulation in front door. Refer to 51 48 060 REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN LEFT OR RIGHT FRONT DOOR (Coupe) and/or 51 48 060 REMOVING AND INSTALLING/REPLACING SOUND INSULATION IN LEFT OR RIGHT FRONT DOOR (Convertible).

Disconnect plug connection (1).

Release screw (3) and remove bracket (2).

Release screws (4) and remove flat motor (5).

Tightening torque, see 67 62 1AZ in 67 62 DRIVES, POWER WINDOWS .

Installation:

Fit flat motor (5) exactly on teeth of power window unit.

Fig 1: Identifying Plug Connection, Bracket & Flat Motor

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out normalization . Refer to 67 62... Notes On Initializing Power Window Unit In Front Door