64 11 866 Removing and Installing/Replacing Servodrive For Blending Flap (Left)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove trim panel for pedal assembly . Refer to 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS (Coupe) and/or 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS (Convertible).
NOTE:
For purposes of clarity, the following graphics show the heater/air conditioner removed.
Disconnect plug connection (1).
Release screws (2).
Remove servodrive at side.
Installation:
Do not twist teeth of servodrive.