64 11 855 Removing and Installing/Replacing Actuator Drive For Central Kinematics (Heater - A/C control)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove right glovebox with housing . Refer to 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING (Coupe) and/or 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING (Convertible).
- Remove storage compartment . Refer to 51 16 200 REMOVING AND INSTALLING STORAGE COMPARTMENT (Coupe) and/or 51 16 200 REMOVING AND INSTALLING STORAGE COMPARTMENT (Convertible).
Detach right footwell heating duct (1) in area (2) in direction of arrow.
Detach right footwell heating duct (1) with adapter (3) from heater/air conditioner and remove in direction of arrow from right rear compartment heating duct (4).
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach actuator drive for central kinematics (3) in direction of arrow from heater/air conditioner (4).
Installation:
Place actuator drive for central kinematics (3) over guide pin (5).