64 11 806 Removing and Installing/Replacing Servodrive For Fresh-/Recirculated-Air Flap
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Servomotors must be re-addressed in the event of replacement!
Addressing can only be carried out with the BMW diagnosis system.
Service functions:
- Body
- Heating and A/C function
- Flap motors
- Re-address flap motors
Necessary preliminary tasks:
- Remove right glovebox with housing . Refer to 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING (Coupe) and/or 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING (Convertible).
Unfasten plug connection (1) and disconnect.
Release screws (2).
Detach servodrive for fresh-/recirculated-air flap (3) in direction of arrow from heater/air conditioner.
Installation:
Place servodrive for fresh-/recirculated-air flap (3) exactly on associated gear teeth.