36 11 523 Removing and installing/replacing an RDC trigger transmitter (rear)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Partially detach rear wheel arch trim

After installation:

Carry out resetting of RDC

Disconnect plug connection (1).

Release screws (2) and remove trigger transmitter.

Fig 1: Identifying Plug Connection And Trigger Transmitter Screws

Courtesy of BMW OF NORTH AMERICA, INC.

E90 and E91 from 09/2008:

Disconnect plug connection (1).

Press holder (2) together and detach trigger transmitter (3) towards front.

Fig 2: Identifying Plug Connection, Holder And Trigger Transmitter

Courtesy of BMW OF NORTH AMERICA, INC.