36 11 121 Removing and installing/replacing an RDC trigger transmitter (front)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Partially detach front wheel arch trim
Press through studs (1) of expander rivets towards rear.
Remove trigger transmitter (2).
Installation:
If necessary, replace expander rivets.
After installation:
- Carry out resetting of RDC