36 11 000 Initializing Run Flat Indicator (RPA)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Checking the tire pressure is based on monitoring the speeds of the wheels in relation to each other. A tire puncture is detected and signalled by way of a deviation in specific speed ratios.
The four tires mounted on the vehicle are monitored while the vehicle is moving.
Initialization must be carried out in each case immediately after tire pressures have been corrected, after tires/wheels have been replaced and after repairs to the air spring system.
The four tires mounted on the vehicle are monitored while the vehicle is moving.
Initialization must be carried out in each case immediately after tire pressures have been corrected, after tires/wheels have been replaced and after repairs to the air spring system.
IMPORTANT:
The Run Flat Indicator does not function when the vehicle is driven with the compact spare wheel.
Version with iDrive:
- Press controller to call up i menu
- Select Settings and press controller
- Select Car/Tires and press controller
- - If necessary, switch to the top field. Turn controller until Tires: RPA is selected and press controller
- Start engine but do not drive off
- Select Confirm tire pressure and press controller
- Drive off. Initialization is completed during the journey
Version without iDrive:
- Start engine but do not drive off
- Touch direction indicator lever up or down until the corresponding symbol and RESET appear
- Press PC button to confirm selection of Run Flat Indicator
- Press PC button for approx. 5 seconds until a check/tick appears after RESET
- Drive off. Initialization is completed during the journey