33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Axle Components

Courtesy of BMW OF NORTH AMERICA, INC.

A wheel/chassis alignment check must be carried out after the following work:

Release of following screw/bolt connections:
- Camber arm to rear axle carrier / wheel carrier
- Trailing arm to rear axle carrier / wheel carrier
- Guide arm to rear axle carrier
- Toe arm to rear axle carrier / wheel carrier
- Control arm to rear axle carrier
Replacement of following parts:
1. Rear axle carrier
2. Camber arm / rubber mount / ball joint
3. Trailing arm / rubber mount
4. Guide arm
5. Wheel carrier / rubber mount / ball joint
6. Toe arm
7. Control arm