LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 135i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 990 (Steering And Wheel Alignment - Repair) >> Pump and oil Supply >> 32 41... Instructions for removing and installing ear clips

32 41... Instructions for removing and installing ear clips

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required: 

See STEERING AND WHEEL ALIGNMENT - SPECIAL TOOLS .

NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.

To remove an ear clip, place special tool 32 1 260  at right angles to ear and cut ear open.

Fig 1: Placing Special Tool To Ear Clip
G04726374Courtesy of BMW OF NORTH AMERICA, INC.

The ear clip can be fitted not only axially but also radially after the hook fastener has been opened.

Fig 2: Identifying Ear Clip
G04726375Courtesy of BMW OF NORTH AMERICA, INC.

Attach hook fastener and press ear together with special tool 32 1 260  .

Fig 3: Pressing Ear Clip With Special Tool
G04726376Courtesy of BMW OF NORTH AMERICA, INC.

Side cutter of special tool 32 1 260  can be used in areas which are difficult to access.

Fig 4: Identifying Special Tool (32 1 260)
G04726377Courtesy of BMW OF NORTH AMERICA, INC.
IMPORTANT: Gap (A) max. 1 mm!
Fig 5: Tightening Dimensions Of Ear Clip
G04726378Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals