24 35 700 Removing And Installing/Replacing Input And Output Speed Sensor (GA6L45R)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After completion of work, check transmission fluid level.
See 00 11 237 CHECKING/TOPPING UP FLUID LEVEL IN AUTOMATIC TRANSMISSION (GA6L45R)
. Use only approved transmission oil. Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove Mechatronics . See 24 34 563 REPLACING MECHATRONICS (GA6L45R) .
Unlock and disconnect plug (1).
Release screws (2).
Detach input and output speed sensor from Mechatronics.
Tightening torque. See 24 30 4AZ in 24 30 HYDRAULIC/ELECTRIC CONTROL PARTS AND CONTROLLING ELEMENTS .