Mounting Engine On Assembly Stand (N52K)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 00 1 450
- 11 3 370
- 11 4 440
- 11 9 261
- 11 9 265
For the following special tools, refer to MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS -- 128I .
For the following special tools, refer to ENGINE- SPECIAL TOOLS (N52K) .
IMPORTANT:
Aluminum screws/bolts must be replaced each time they are released.
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage).
Necessary preliminary tasks: