13 62 532 Replacing radiator outlet coolant temperature sensor (N51)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of scalding!
Only perform these tasks on an engine that has cooled down.

Recycling

Catch and dispose of escaping coolant.

Observe country-specific waste-disposal regulations.

Disconnect plug (1) from temperature sensor.

Fig 1: Disconnecting Plug From Temperature Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Press retaining clips (1) together.

Remove temperature sensor (2) in direction of arrow.

Fig 2: Identifying Temperature Sensor And Retaining Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check function of DME.

Check cooling system for leaks. See 17 00 009 CHECKING COOLING SYSTEM FOR WATER LEAKS .

Check coolant level and top up if necessary.