11 31 090 Installing And Removing/Replacing Chain Tensioner Piston (N51)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Release chain tensioner (1).
Tightening torque. See 11 31 5AZ in 11 31 CAMSHAFT N51 B30 .
IMPORTANT:
Have a cleaning cloth ready. A small quantity of engine oil will emerge after the screw connection has been released.
Make sure no oil runs onto the belt drive.
Make sure no oil runs onto the belt drive.
Installation:
No sealing ring is fitted during series-production assembly.
A sealing ring must be fitted by service personnel when the chain tensioner is fitted.
If the chain tensioner is reused, its oil chamber must be drained. Place chain tensioner on a level working surface and slowly compress.
Repeat procedure twice.
Assemble engine.