General Information
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- The following procedures are used for repairs:
- Gas brazing
- Tinning
- The MIG soldering procedure is not used in repairs for strength reasons. MIG soldered/brazed seams used in series production are replaced in repairs by MAG weld seams.
- Areas brazed in vehicle production are joined during repairs with the same procedure.
- It is possible when straightening steel parts to correct irregularities smaller than 2 mm with filler.
If in exceptional cases the irregularities are in excess of 2 mm, these areas must be tinned.
Only visible areas of the outer skin and on the support carrier must be tinned.
All areas which have covers on the vehicle are not to be tinned.
NOTE: Only applicable within the European Union!European used-car regulations prohibit the use of tin containing lead in motor vehicles introduced after 01.07.2003!