The Body Must Be Anchored As Follows For Reshaping

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

If using vehicle-specific/universal straightening attachment sets (Carbench/Celette), it is necessary to secure the body additionally with 4 retaining clips to the spot flange of entrance or to the 4 jacking points. The spot flange (if available) is to be preferred.

If using universal electronic or mechanical straightening systems (Car-O-liner/Celette), it is necessary to secure the body with 4 retaining clips to the spot flange of entrance or to the 4 jacking points. The spot flange (if available) is to be preferred. In addition anchor at least 2 points with the securing set.

Failure to comply with these instructions will result in damage to the body during reshaping in non-damaged areas. Vehicle-specific straightening attachments and universal mounts may be damaged.