LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 135i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 701 (Collision - Body Panel Repair (E92 & E93)) >> Body Panel Repair General Information >> 41 00... Opening Welded Connections

41 00... Opening Welded Connections

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2013 BMW 328xi, 2013 BMW 328i, 2012 BMW 328xi, 2012 BMW 328i, and 2011 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Opening weld spots (resistance pressure spot welding): 
    • Set punch mark in center of weld spot. Set 8 mm dia. weld spot drill bit on punch mark and drill through top metal sheet.

      Or open weld spot with Vario Drill spot welding cutter.

      NOTE: Because the weld spots may have surface-hardened, grind them if necessary with an angle grinder and paper grinding disk.
  2. Opening laser weld seams: 
    • Place angle grinder with grinding disk on laser weld seam and grind through top metal sheet. Be careful not to cut through and damage sheet metal underneath.
scientia non olet · About LEMON Manuals