33 32 160 Removing and installing/replacing compression strut for rear axle carrier
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2013 BMW 328i, 2012 BMW 328i, 2011 BMW 328i, 2010 BMW 335i, and 2010 BMW 328i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions
for raising the vehicle.
Driving without compression struts is not permitted!
Risk of damage!
The rear axle carrier must be supported at the front if both compression struts have to be replaced!
Necessary preliminary tasks:
- Remove underbody cover
Release screw (1).
For tightening torque refer to 33 32 12AZ in 33 32 CONTROL ARMS AND STRUTS .
Unfasten screws (2).
Installation:
Replace screws.
For tightening torque refer to 33 33 2AZ in 33 33 REAR AXLE SUSPENSION .
Release screw (4) and remove compression strut (3).
Installation:
Check threads for damage; if necessary, repair with Helicoil thread inserts.
For tightening torque refer to 33 33 1AZ in 33 33 REAR AXLE SUSPENSION .