LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2009 >> 135i 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Air Bag Restraint Systems) >> Removal & Installation >> Side Air Bag Module >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 BMW M3, 2005 BMW 330xi, 2005 BMW 330i, 2005 BMW 330Ci, and 2005 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove appropriate front door trim panel, rear door trim panel, or rear seat side trim panel. Disconnect side air bag module electrical connector. Remove and discard side air bag mounting screws. Remove side air bag module from vehicle.
  3. To install, reverse removal procedure. Use NEW micro-encapsulated side air bag module mounting screws and tighten to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals