51 23 105 Removing And Installing/Replacing Right Hood/Bonnet Lock

WARNING:

Scalding hazard!

Only perform work after engine has cooled down.

Release screws (1) and remove intake duct (2).

Release screws (3) and feed out hood/bonnet lock (4) sideways.

Tightening torque, see 51 23 2AZ in 51 23 HOOD/BONNET LOCKS .

Fig 1: Identifying Intake Duct With Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Engine hood/bonnet lock (2) shown without attachment parts for purposes of clarity.

Disengage Bowden cable (1) from hood/bonnet lock (2).

Fig 2: Disengaging Bowden Cable From Hood/Bonnet Lock

Courtesy of BMW OF NORTH AMERICA, INC.