51 33 000 Removing And Installing (Replacing) Power Window Unit In Left Or Right Front Door: Notes

WARNING:

Risk of injury!

Carry out work on the power window unit only when the power window motor is de-energized.

Necessary preliminary tasks:

Peel back film (1) and loosen nuts below.

Release nuts (2) and feed out rear section of power window unit (3).

Tightening torque, see 51 33 1AZ in 51 33 POWER WINDOWS, FRONT .

Installation:

Replace defective film (1) if necessary.

Fig 1: Identifying Power Window Unit Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen window regulator (3) at bracket (1).

Release nuts (2) and completely feed out power window unit (3).