51 41 060 Removing And Installing (Replacing) Armrest On Door Trim Panel, Front Left Or Right: Replacement
Saw off welding pins (1) on armrest (2) down to measurement (A).
A= 2.0 ± 0.5 mm
Installation:
Armrest:
- position on door trim panel (1)
- secure at front and rear with repair screw (2)
- align until bores (3) are centrally located
- tighten down, starting in middle
Tightening torque, see 51 41 2AZ in 51 41 FRONT DOOR TRIM PANEL WITH ARMRESTS .
NOTE:
If bores (3) have not been correctly drilled through, increase tightening torque according in order to ensure that armrest is firmly seated.