Initial Fitting

Place drilling hole template (1) on bumper (2).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

Tightening torque, see 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 1: Identifying Drilling Hole Template On Bumper

Courtesy of BMW OF NORTH AMERICA, INC.

Place drilling hole template (1) on radiator grille (2) and bumper (3).

NOTE: Hole diameter = 2.5 mm (see template).

Drill holes according to number/license plate.

Remove template (1) and secure number/license plate with screws provided.

Tightening torque, see 51 11 3AZ in 51 11 FRONT BUMPER .

Fit protective caps.

Fig 2: Identifying Drilling Hole Template On Radiator Grille & Bumper

Courtesy of BMW OF NORTH AMERICA, INC.