Adjusting Longitudinal Direction

Slackening hook screws using special tool 51 3 240 .

Adjust X- and Z-directions by moving side window glass (2).

Tightening torque, see 51 37 2AZ in 51 37 SIDE WINDOWS, ELECTR. ACTUATED .

Fig 1: Slackening Hook Screws Using Special Tool 51 3 240

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

The tightening torque to be set 51 37 2AZ in 51 37 SIDE WINDOWS, ELECTR. ACTUATED (MDE) is reduced when special tool 51 3 240 is used. Depending on the torque wrench used, this must be calculated according to the adjacent equation:

MDE Torque to be set

MDV Prescribed torque (without special tool)

lj = Standard adjustment length with adjusting tool

l1 = Effective length of torque wrench

l2 = Inside dimension of adjusting tool

lw = Inside dimension of insertion tool (here lw = 246 mm+l2)

Fig 2: Identifying MDE Adjacent Equation

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If screwing is performed from the inside of the door (removed door trim panel), the tightening torque to be set 51 37 2AZ in 51 37 SIDE WINDOWS, ELECTR. ACTUATED (without special tool) must be observed.